The component includes PRO60SE copolymer woofer with rubber surround. Each woofer has a 1-1/2″ diameter voice coil and neodymium magnet, which has a high power to weight ratio and compact size;. About one-tenth the size of the traditional iron ferrite magnets of the speakers has a cast aluminum basket, and an integrated cooling Radiavent days Twin aluminum heat sink to draw heat from the voice coil, increasing power handling.
The PRO60SE includes 1″ type M-1 anodized aluminum dome tweeter with AMD (Amplitude Modification Device) for a smooth high frequencies, and linearity. AMD is a patented acoustical tuning device that uses precisely measured hollow tubes positioned in front of the tweeter to reorientation short-wave energy and create an extremely smooth, flat response. This is without expensive electronic components, the sound can degrade the purity to be done. The included Quick-fit mounting cup simplifies tweeter installation. The tweeters come to the woofer with the axis-mount bracket, they can be removed and flush with the supplied brackets or wall-mounted at an angle.
PRO60SE The system comes with a separate woofer and tweeter crossover for each channel. Each crossover can be installed separately, docked in pairs or all four together and crossovers docked mounted as a unit. The crossover inputs and outputs set screw and accept bare wire up to 10 gauge.
The following crossover adjustments are made:
BUY BOSTON ACOUSTICS PROSERIES 60SE NOW AT THE BEST PRICE!
Tweeter Attenuation:
The tweeter crossover, you can tweeter output by the included jumper to the appropriate terminals, select one of un-damped tweeter output (0dB attenuation) or an attenuated output of-2dB and-4dB. The factory setting is-2dB.
Axis/Component Configuration:
The woofer crossover, you can mount the output for the axis or component configuration. If the tweeters mounted on the woofer with the axle bracket is, should the jumpers on the Axis terminals (factory location) to be placed. If the tweeter is mounted away from the woofer and separately in the flush-mount or angled surface mount cups, the jumper should be placed on the component terminals.
Input Configurations:
Separate entrances: Each crossover (woofer and tweeter) has independent inputs, so you Bi-amp (separate power supply for the tweeter and woofer with different amplifier channels) or bi-wiring (power of the woofer and tweeter with separate lines of the same amplifier channels) system. together, the integrated signal bridge that shorts the tweeter and woofer inputs to Bi-amp or bi-wiring is removed.
Single Input: When you turn the component system with a single full-range input, you must connect to the woofer and tweeter crossover inputs together. This can be supplied with the signal if the bridge tweeter and woofer crossovers mounted together.
BUY BOSTON ACOUSTICS PROSERIES 60SE NOW AT THE BEST PRICE!
Daisy Chain: When not assembled, the tweeter and woofer crossovers are chained together. The output of the amplifier is connected to one of the crossover to the inputs, the signal output of crossover is that then wired to the other crossover input.
Crossover Dimensions:
- Length: 6.476″
- Height: 1.560″
- Width:
- Individual: 1.961″
- Pair: 3.789″
- All four: 7.405″
BUY BOSTON ACOUSTICS PROSERIES 60SE NOW AT THE BEST PRICE!
